How do I delete an iSCSI target?

How do I delete an iSCSI target?


  1. In the left MMC pane, select the instance of SnapDrive from which you want to disconnect an iSCSI target.
  2. Double-click iSCSI Management.
  3. Select the iSCSI session that you want to disconnect.
  4. From the menu choices at the top of MMC, navigate to Action > Disconnect Target.

How remove stale iSCSI target Linux?

The Solution

  1. Get downtime for reboot.
  2. Remove directory: # rm -r /var/lib/iscsi/nodes/iqn-bad-node. Above will get rid of the config file and IP + port for this IQN – so OS won’t use it anymore from boot.
  3. Make sure that /etc/fstab file does not hold any information about bad IQN:

How do I remove inactive iSCSI target?

Managing an iSCSI Target

  1. Go to Main Menu > Storage Manager > iSCSI > iSCSI Storage.
  2. Select a target.
  3. Click Action.
  4. Select an action. Target Action. Description. Deactivate. Disable an active target and disconnect all connected iSCSI initiators. For details on target statuses, see iSCSI Targets and LUNs. Activate.

How do I end an iSCSI session?

From the Storage Virtual Machine drop-down list, select the Storage Virtual Machine (SVM) for the iSCSI target. From the Host drop-down list, select the host for the session. From the list of iSCSI sessions, select the session that you want to disconnect and click Disconnect Session.

How do I find the iSCSI target in Linux?

You can discover iSCSI target portals by using the internet storage name service (iSNS) method. You can connect to a specific portal on a discovered target by using the iscsiadm command. You can log out of a specific system target or you can log out of all established sessions.

How do I log into iSCSI target in Linux?

Below are few most commonly used iscsi connection commands.

  1. Discover targets at a given IP address: # iscsiadm –mode discoverydb –type sendtargets –portal –discover.
  2. Login, must use a node record id found by the discovery:
  3. Logout:
  4. List node records:
  5. Display all data for a given node record:

What is Iscsiadm?

The iscsiadm utility is a command-line tool allowing discovery and login to iSCSI targets, as well as access and management of the open-iscsi database. Open-iscsi does not use the term node as defined by the iSCSI RFC, where a node is a single iSCSI initiator or target.

How stop iSCSI initiator service in Linux?

How to delete iscsi target from initiator ( CentOS / RHEL 7 )…

  1. Steps to delete iscsi target.
  2. Update /etc/fstab.
  3. Un-mount the disk.
  4. Disconnect the iscsi disk from that target.
  5. Delete the connection.
  6. Stop the iscsi service (optional)

What is iSCSI target discovery?

An iSCSI target is a logical target-side device that hosts iSCSI LUNs and masks to specific iSCSI initiators. You need to configure the iSCSI initiator to discover the iSCSI target so that the ESXi host can access LUNs on the target.

How do I check my iSCSI sessions?

On the storage system console, enter the following command: iscsi session show [-v | -t | -p | -c] [ session_tsih …] -v displays all information and is equivalent to -t -p -c. -t displays the TCP connection information for each session.