How do you cut a countertop post?
How do you cut a countertop post?
Put on protective eyewear. Cut the countertop along the line with a circular saw equipped with a fine-toothed blade. Alternatively, make the cut with a jigsaw if the countertop has a backsplash attached. Smooth the exposed rough edge with a 220-grit sanding block.
How can I cut my countertop without chipping?
You can minimize the potential for chipping if you use a finish blade with lots of teeth, making sure the sharp is keen. You can further reduce the chance of chipping by using masking tape along the cut line and cutting through the tape. As with all cutting, measure at least twice and mark the line well and clearly.
What saw is best for cutting a hole in a countertop?
To cut through laminate countertops, you can use a hand saw, but a circular saw makes the job much quicker. Because a circular saw can produce jagged edges and chip the laminate, your best bet is to lay the laminate face-side down and cut from the back to the front.
What is the proper blade for countertop cutouts?
Cutting a post-form laminate countertop to length requires a clean, straight cut. The best DIY tool for the job is a circular saw with a fine-tooth carbide blade made for laminate (the same blades are typically sold for non-ferrous metals and other types of plastics). You can also use a jigsaw with a fine-tooth blade.
How do I post a laminate form?
How is Post-Formed Laminate Made? Initially, laminate is made through fusing layers of both core and decorative paper into one single sheet. This sheet is then soaked with resins and pressed together using high levels of heat. After the laminate has been formed, it is heated to soften the resins within the material.
Will Lowes cut sink hole in countertop?
Lowe’s offers an all-inclusive option regarding countertop installation, which includes the following services: Delivery and installation. One unpolished cutout (sink or cooktop) Four faucet hole cutouts.
How do you cut a sink hole in a solid surface countertop?
Instructions
- Create Sink Outline on the Counter With Painter’s Tape. Lay the sink face-down on the solid surface.
- Drill 2 Pilot Holes Per Straight Side. Think of your sink cutout as happening in two phases: straight lines and corners.
- Clamp Down Your Cutting Guide Track.
- Make Your Straight Cuts.
- Make Your Corner Cuts.
What is a triple chip saw blade?
A Triple Chip Grind (TCG) has a trapezoidal tip that cuts a groove with slanting sides. This is followed up by a square top tip that makes the side of the groove square. The first tooth, or lead tooth, has a double 45 degree angle corner bevel.