How do you reset the drum light on a Brother printer?

How do you reset the drum light on a Brother printer?

Reset the Drum Counter

  1. Close the front cover.
  2. Make sure the machine is turned on.
  3. Press. (Settings).
  4. Press All Settings. (This step might be skipped in some models.)
  5. Choose Machine Info. or Machine Information => Parts Life.
  6. Press and hold Drum or Drum Life until the machine’s display message changes.
  7. Press Yes.
  8. Press.

How do you reset the drum on a Brother printer HL L5100DN?

HL-L5000D/HL-L5100DN/HL-L5200DW/HL-L5200DWT/HL-L6200DW/HL-L6200DWT

  1. Make sure the machine is turned on.
  2. Open the front cover.
  3. Press and hold OK for about two seconds to display the [Drum Unit] option, and then press OK.
  4. Press for [Reset] to reset the drum counter.
  5. Close the front cover of the machine.

How do you reset the drum on a Brother printer HL L2370dw?

How to Reset Drum on Brother HL-L2370dw

  1. Make sure the printer is on.
  2. Close the front cover.
  3. Hold down the “OK” button and the “up” arrow at the same time.
  4. Press the “OK” button to select “Drum”.
  5. Select the “down” button to reset the drum counter.
  6. The printer will say accepted when drum is reset.

Why is the red light flashing on my Brother printer?

Turn on the printer. If the Status LED lamp continues to flash in red, the printer needs to be service. Press the [Feed] button. If the LED lamp starts to flash in red after pressing the [Feed] button, then DK roll may not have installed into the printer correctly.

How do you reset the drum on a Brother HL 2240d?

How to reset the drum counter:

  1. Make sure the machine is on, then open the front cover.
  2. Press and hold the “Go” button for about 4 seconds or until all the LEDs light up.
  3. Release the “Go” button and close the front cover.
  4. If the drum light is off, the drum unit is reset.

How do I clear the error on my Brother HL 2270DW?

For the factory reset, just press the GO button. After pressing the GO button, time to turn on the printer. After turning the printer off, just hold on to the GO button. Here, all the LEDs will turn off except the Ready LED.

How do you clear a drum error?

If you reset the drum counter during the life of the drum unit currently being used, the remaining drum life will not be displayed accurately.

  1. Make sure that the machine is turned on.
  2. Open the front cover.
  3. Press and hold OK for 2 seconds.
  4. Press the Up arrow key or 1 to reset the drum counter.
  5. Close the front cover.

How do you slide the green tab on a drum unit?

On each assembly, locate the green tab on the top, left side. Clean the primary corona wire inside the drum unit by gently sliding the green tab from right to left and left to right several times. Be sure to return the green tab to the home position before reinstalling the assemblies back into the machine.