What is Frame Relay example?
What is Frame Relay example?
Frame relay is a packet-switching telecommunications service designed for cost-efficient data transmission for intermittent traffic between local area networks (LANs) and between endpoints in wide area networks (WANs). The service was once widely available and implemented.
What is Frame Relay in Cisco Packet Tracer?
Frame Relay is a protocol standard for WAN internetworking which provides a fast and efficient method of transmitting packets through the network.
What is Frame Relay Cisco?
In frame relay, the routers connected to remote networks are usually the DTE devices while the frame relay switch is usually the DCE device. The frame relay switches move data frames from the host networks across the WAN network to the remote DTE devices.
Why is frame relay used?
Frame relay is commonly used to connect two or more LAN bridges over large distances. The iSeries system supports these frame-relay network connections: Frame relay direct network: Allows data that uses SNA or TCP/IP communications over a frame-relay network to move at speeds of up to 2.048 Mbps.
How does a frame relay work?
How Does Frame Relay Work? Frame relay uses packet switching technology. This means that it breaks data, such as call data, into smaller packets, also known as frames, to transmit it through a shared frame relay network. These data packets are then reassembled at the data’s destination.
What is DLCI in Frame Relay?
A data link connection identifier (DLCI) is a Frame Relay 10-bit-wide link-local virtual circuit identifier used to assign frames to a specific PVC or SVC. Frame Relay networks use DLCIs to statistically multiplex frames. DLCIs are preloaded into each switch and act as road signs to the traveling frames.
Which of the following information is viewed in Frame Relay config with help of show interface command?
The information shown by the show interface serial command offers the following information on Frame Relay: The type of Frame Relay encapsulation used on an interface or PVC. The keepalive interval configured. The Frame Relay LMI type used.